Comments on: 3D Printers for Beginners - 3DPrinting.com

By: Peter Strikwerda

Peter Strikwerda — Tue, 31 Dec 2019 11:06:19 +0000

In reply to alan flwtt. Hello Allan. It's best to reach out to CTC directly or if that's difficult try to find a CTC Facebook community you can join.

By: alan flwtt

alan flwtt — Mon, 30 Dec 2019 18:52:28 +0000

have recently acquired a 2nd generation ctc 3d printer which ive been told has never been used and by the way it was packaged i don’t have any reason to doubt it but when i go to install the drivers my MacAfee comes up that it has a virus or trojan on it and wont install the drivers
any assistance would be gratefull

By: Peter Strikwerda

Peter Strikwerda — Wed, 23 Jan 2019 09:34:53 +0000

In reply to Andrew. Hey Andrew - scanners are not included in these machines. 3D scanning is not something we are very familiar with - we only know it's not as easy as one might think. We have a few scanners listed here: https://3dprinting.com/3d-scanners/

By: Andrew

Andrew — Tue, 22 Jan 2019 20:54:33 +0000

I need to make parts for vehicles, is there a scanning tool that will allow me to scan the part I need and basically have the printer build it to the specs it scans? Is it already included in these machines? I’m totally new to this. Please help

By: Peter Strikwerda

Peter Strikwerda — Wed, 12 Dec 2018 09:11:29 +0000

In reply to Cathy Nealey. We haven't tested it yet

By: Cathy Nealey

Cathy Nealey — Tue, 11 Dec 2018 19:14:13 +0000

How does the Snapmaker 3 in 1 3D printer rate?

By: Suresh Panchal

Suresh Panchal — Wed, 01 Aug 2018 16:34:51 +0000

Very Helping knowledge